Your Source for GD&T Training and Materials

Back to GD&T Tips

Angularity

   Use Two Datum References for Angularity!

When setting up a part for the measurement of angularity on a sine bar, it is difficult to orient the part before performing the inspection. 
This problem is overcome if a second datum is referenced in the angularity callout

 

Back to GD&T Tips

Home About GD&T Training Software Catalog GD&T Resources Prototyping Contact Site-Map

© 1997 – 2008, Tec-Ease, Inc. All rights reserved.

Virtualtech Web Site Design and Promotion, Inc.